How to hook up a rca line out converter

If you can't find a convenient ground screw or bolt, drill a hole for one be careful not to drill into any wiring, the gas tank, or a gas or brake line.

Need help i have a vr-3 headunit and a vr-3 amp i have the amp were it will turn on but im haveing truble with the rca cord i have only one sub hook up and a 2 channel amp i have the y splitter hooked up to the one sub conecter and then both my rca cords hooked into that and on the amp i have them pluged into the line in holes and my speakers are hooked up the amp is not running my speakers i have the out ports and dont know how to hook them up and were to hook them up.

How to hook up a rca line out converter

How To Install a Line Out Converter (LOC) | Installation and Tips

Get 10% off all NVX products with Coupon Code: NVXVID10 Shop all NVX products: ...

Kept the factory stereo, so i had to use a 2-line converter to connect the rear speakers to the rcas in the subwoofer.

, even if it didn't come with instructions, if you bought your line output converter at crutchfield, you could call tech support for free help wiring your system.

How to hook up a line out converter

How to install a LOC - line output converter

AVE MONEY ON YOUR LOC BELOW I did a video a few years ago on how to install a amp to a factory radio n there was some ...

I have a 2008 mercury milan i need to hook up a l7 speaker and my boss amp help step by step.

Do i have to use both sets of wires to hook to the speakers or is 1 sufficient?

How to hook up a scosche line out converter

Line output converter installation

Like my page! This video describes how I installed a line output converter in my 1984 ...

Otherwise you'll need to get a line output converter to send rca line-level signals to the amp from the speaker wiring.

My name is adam i hooked up a 1300 wat apm to my old mobile alero go and with 1600 watt wires and it keeps kicking off the apm if i turn the bass even up to -3.

how to install an amp to a factory radio

Get the best price on the LOC below check out part 2 on installing an LOC DONT FORGET TO VISIT ...

.com/inksaul This video describes how I installed a line output converter in my 1984 volkswagen rabbit cabriolet.

There are two ways to do this: get a line output converter (loc) that'll adjust the speaker-level signal for your amp's input, or get an amplifier with speaker-level inputs.

Pac Sni-35 Line Out Converter in 2004 Subaru Forester XT

Follow up video to my Scosche FAI-3A Review. There no doubt are other ways to install loc's, but this one works well if you need a ...

Using a fused distribution block with two 40-amp fuses, or installing them inline after the block, will further protect your amps and installation.

Make sure you don't drill into any electrical or gas lines check both sides of the firewall.

How to connect RCA's to a Stock Stereo Line out Converter T-Spec V10

Uploading old vids I had saved still dont have a camera.

Also i've hooked up an old amp that i knew worked and still had no sound to subs.

If so, you can usually find the code and resetting procedure in the vehicle's owner's manual, online, or from a car dealership service department (be prepared to prove you own the vehicle).

LOC90 - Line Output Converter - Scosche

Find the LOC90 Here: Facebook: Twitter: ...