Therefore, for a large light bar you can use a smaller cab switch and smaller wire on the switch circuit.
Relays are inexpensive and most handle 40a of current, which is more than enough for even large led light bars.
Lot more can be said in regard to how to wire an led light bar.
How to hook up led light bar to atv
The first step in doing this is to connect the wires from the light itself to your relay switch.
The power wire of the new light to the power wire of the old light with solder and heat shrink tubing (dws-x) or perma-seal butt connectors (psc-x).
The relay to a suitable location and test the lights to make sure the circuit works.
How to hook up my led light bar
The lights with the provided hardware, being sure not to over tighten the hardware (you will need to adjust them in step 7).
Its founding in 2002, super bright leds has been committed to providing customers with outstanding service, expertise, and the highest quality products in led lighting.
The lighting side of the wiring harness from the battery to the light(s) in a safe, secure manner.
How to hook up multiple led light bars
The new led work light or off road light bar has an atp or dt connector that you wish to utilize, the corresponding atp (atp-mpt) or dt (dt-mpt) pigtails are available.
Lights may not have dt or atp connections on them but the connectors can be added from the harness kit or purchased separately (dt-fpt or atp-fpt).
The lights with the provided hardware, being sure not to over tighten the hardware (you will need to adjust them in step 4).
Picked out a great, ultra-bright led light bar that is just waiting to make its permanent home on your vehicle.
The positive wire from the light bar attaches to terminal 87 and the light bars negative wire attaches to a vehicle ground.
In order to help you get your light bar installed as smoothly and quickly as possible, here is a guide to mounting and wiring an led light bar:Mount the light to your vehicle.
Learning how to wire and led light bar correctly ensures reliability and avoids unsafe operating conditions or damage to your vehicle.
#7:add a dual waterproof connector near the light bar for easy disconnection when the light needs to be removed.
You get out on the road its a good idea to give your light one final inspection.
Starting to drill hole(s), check behind locations to insure nothing will be damaged while drilling light mounting holes.
Steps need to be completed for each mode for any selectable multibeam and dual color light bars.
, turn your light off and on a few times to make sure the switch is working like it should.